NEC SL 1000 - 26-02: Dial Analysis Table for ARS;LCR

Program 26 : ARS Service & Least Cost
Routing
26-02 : Dial Analysis Table for ARS/LCR
Level:
IN
Description
Use Program 26-02 : Dial Analysis Table for ARS/LCR to set pre-transaction tables for selecting
Automatic Route Selection (ARS/F-Route).
• Service Type 1 (Route to Trunk Group Number) - The number routes to a trunk group.
• Service Type 2 (F-Route Selected) - The number is controlled by the F-Route table.
Input Data
Dial Analysis Table Number 1 ~ 400
Item
No.
Item Input Data Default Related
Program
01 Dial Maximum of 16 digits (0 ~ 9,
*
, #, @) No Setting
02 ARS Service Type 0 = No Service (Call Restricted)
1 = Route to Trunk Group
2 = Select F-Route Access
0
03 Additional Data/Service
Number
If Service Type 1 (in 26-02) : Select Trunk Group
Number
0 ~ 25 (Trunk Group Number 0 = No Route)
If Service Type 2 (in 26-02) :
F-Route Time Schedule Not Used = 0 ~ 100
(F-Route Table Number).
Refer to Program 44-05 : ARS/F-Route Table on
page 2-402.
F-Route Time Schedule Used = 0 ~ 100
(F-Route Selection Number).
Refer to Program 44-04 : ARS/F-Route Selection
for Time Schedule on page 2-401.
0 44-04
44-05
04 ARS Class of Service 0 ~ 16
0 = No ARS Class (Call Restricted)
0
05 Dial Treatment for ARS 0 ~ 15 0
06 LCR Carrier Table 0 ~ 25 0
07 Network Specified Parameter
Table
0 ~ 16 0 26-12
Conditions
None
ISSUE 3.01
SL1000/SL1100
Programming Manual 2-319
Program
26