NEC SL 1000 - Section 5 USING KEYS to MOVE AROUND in the PROGRAMS; Table 1-1 Keys for Entering Data (SL1000)

To save a customer’s database, a blank Compact Flash (CF) Card is required. Insert the CF Card into the
CPU and, using Program 90-03, save the software to the CF Card. (Program 90-04 is used to reload the
customer data if necessary.) Note that a CF Card can only hold one customer database. Each database to
be saved requires a separate drive.
CF card
CF Slot (CN2)
CPU card
VMDB-C1
SECTION 5 USING KEYS TO MOVE AROUND IN THE PROGRAMS
Once you enter the programming mode, use the keys in the following chart to enter data, edit data and
move around in the menus.
Table 1-1 Keys for Entering Data (SL1000)
When you want to ... Telephone Programming
Enter Data into program 0 ~ 9,
*
, #, Line Key (1 ~ 6)
Next Index Cursor Key (Up)
Prior Index Cursor Key (Down)
Select Data Line Key (1 ~ 6)
All Clear Flash
Register Hold
Enter
Go Back to Prior Screen Mute
Clear / Back
Move Cursor Jump Up/Down DND (IP Phone Only) or DND / CONF
Delete single character Clear / Back
Next Page -
Toggle between Number/Character Help
While in a Entering Number
Prior Page -
Quit the programming Speaker
Exit
Move Cursor to Left Cursor Key (Left)
Change Program Number -
Change Index Number
Change Program Number -
Change Index Number
SL1000/SL1100 ISSUE 3.01
1-4
Introduction