NEC SL 1000 - Trunk Access Map Setup

Program 14 : Trunk, Basic Setup
14-07 : Trunk Access Map Setup
Level:
IN
Description
Use Program 14-07 : Trunk Access Map Setup to set up the Trunk Access Maps. This sets an
extension access options for trunks. For example, an extension can place only outgoing calls on
trunks to which it has outgoing access. There are 126 (SL1000) 096 (SL1100) Access Maps with all
126 (SL1000) 096 (SL1100) trunk ports programmed in Map 1 with full access.
An extension can use one of the maps you set up in this program. Use Program 15-06 to assign Trunk
Access Maps to extensions. Each trunk can have one of eight access options for each Access Map.
Emergency calls will override Program 14-07 settings.
Input Data
Access Map Number
001 ~ 126 (SL1000)
001 ~ 096 (SL1100)
Item
No.
Item Input Data Description Default
01 Access
Map
0 = No access
1 = Outgoing access only
2 = Incoming access only
3 = Access only when trunk on Hold
4 = Outgoing access and access when trunk on
Hold
5 = Incoming access and access when trunk on
Hold
6 = Incoming and Outgoing access
7 = Incoming access, outgoing access and access
when trunk on Hold
Trunk Port Number =
001 ~ 126 (SL1000)
Trunk Port Number =
001 ~ 096 (SL1100)
Refer below
Default
Access map No. Trunk Port No. Default
1 1 7 (T, R, H)
2 7 (T, R, H)
: :
126 (SL1000)
096 (SL1100)
7 (T, R, H)
2 1 0 (No access)
2 0 (No access)
: :
126 (SL1000)
096 (SL1100)
0 (No access)
ISSUE 3.01 SL1000/SL1100
Programming Manual 2-121
Program
14