Program 90 : Maintenance Program
90-36 : Firmware Update Time Setting
Level:
IN
Description
Note: This program is available only via telephone programming and not through PC Programming.
Use Program 90-36 : Firmware Update Time Setting to define the data for the firmware update
feature. This data is available to set from the PC Programming FW update feature.
The following firmware is available to update with this feature:
• main.bin
• Dspdbu.bin
• dsp.bin
• intradbu.bin is not supported
Input Data
Item
No.
Item Input Data Default Description
01 Firmware Update Sched-
ule Time
Read Only:
Year : 0 ~ 99
Month : 0 ~ 12
Day : 00 ~ 31
Hour : 00 ~ 23
Minute : 00 ~ 59
0 Set the time to update the firmware us-
ing a compact flash card.
Time registration fails if an expired
time is registered.
02 Update mode Read Only:
0 = Non Active
1 = Activated
0 Activate the Firmware Update feature.
If this setting is 1, new firmware on the
compact flash card updates according
to the setting at 90-36-01.
03 Update Report Read Only:
Maximum 256 charac-
ters
- Output a report when the update is
executed and saves one copy on the
system. If a new update occurs, the
new report overwrites the old report.
Refer to the Sample Report on
page 2-600 shown.
Sample Report
Result
Report Display
Update Success Update Success
Update Fail Update is fail. Since ‘A’ drive is not available.
Update Fail Update is fail. Since main up is not exist on A drive.
Update Fail Update is fail. Since Time is expired.
SL1000/SL1100 ISSUE 3.01
2-600 Program 90 : Maintenance Program
Program
90
To Next Page
Loading...
