NEC SL 1000 - Section 4 HOW to EXIT PROGRAMMING MODE

5. Dial the system password + Hold.
Refer to the following table for the default system passwords. To change the passwords, use
90-02 : Programming Password Setup on page 2-549.
Program Mode
(SL1000)
Program Mode
Base Service OP1 OP2
(SL1100)
Password User Name Level Programs at this Level
******
nec-i 1 (MF) Manufacture Level (MF) :
80-02, 81-04, 81-05, 82-02 (SL1000), 82-05, 82-08 (SL1100)
12345678 tech 2 (IN) Installation (IN) :
All programs in this section not listed for MF, SA, & SB
0000 admin1 3 (SA) System Administrator - Level 1 (SA) :
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17, 10-18, 10-23,
10-24, 10-25, 10-28, 10-29, 10-45, 12-02, 12-03, 12-04, 12-08, 15-01,
15-07, 15-09, 15-10, 15-11, 20-16, 20-34, 21-07, 21-14, 22-04, 22-11,
22-17, 25-08, 30-03, 30-04, 32-02, 45-02, 84-22, 90-03, 90-04, 90-06,
90-07, 90-19, 90-57, 90-58, 90-59, 90-65
9999 admin2 4 (SB) System Administrator - Level 2 (SB) :
13-04, 13-05, 13-06, 13-11, 15-14 (SL1100), 21-20
SECTION 4 HOW TO EXIT PROGRAMMING MODE
To-exit the programming mode :
When you are done programming, you must be out of a program option to exit (pressing the Mute key
will exit the program option).
1. Press Mute key to exit the program options, if needed.
Program Mode
(SL1000)
Program Mode
Base Service OP1 OP2
(SL1100)
2. Press Speaker. If changes were to the system programming, "Saving System Data" is displayed.
3. The display shows "Complete Data Save" when completed and exits the telephone to an idle
mode.
ISSUE 3.01
SL1000/SL1100
Programming Manual 1-3