Program 10 : System Configuration Setup
10-63 : DHCP Client Setting
Level:
IN
Description
Use 10-63 : DHCP Client Setting to set the data of DHCP Client.
Input Data
Item
No.
Item Input Data Description Default
01 DHCP Client Mode 0 = Disabled
1 = Enabled
If you are using IP phones/trunks it is rec-
ommended to not use the DHCP client
function, a static IP address would be pre-
ferred. If you are going to still use the
DHCP client function then the DHCP serv-
er should be setup so that the same IP ad-
dress is always provided to the system.
When changing this program a system
reset is required.
0
Conditions
None
Feature Cross Reference
None
ISSUE 3.01 SL1000/SL1100
Programming Manual 2-59
Program
10
To Next Page
Loading...
