NEC SL 1000 - 44-02: Dial Analysis Table for ARS;F-Route Access

Program 44 : ARS/F-Route Setup
44-02 : Dial Analysis Table for ARS/F-Route Access
Level:
IN
Description
Use Program 44-02 : Dial Analysis Table for ARS/F-Route Access to set the Pre-Transaction
Table for selecting ARS/F-Route.
Input Data
Dial Analysis Table Number 001 ~ 120
Item
No.
Item Input Data Description Default
01 Dial Up to four digits
(SL1000)
Up to eight digits
(SL1100)
(Use line key 1 for a
Don’t Care digit, @)
Set the number of digits to be analyzed by
the system for ARS routing.
No Setting
02 Service Type 0 = No setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Ana-
lyze Table (Option)
• Service Type 1 (Extension Number)
The number goes to an extension after
deleting the front digit(s).
Additional Data
Assign the digit(s) to be deleted on top
of the number for extension number us-
age. At least one digit must be deleted.
• Service Type 2 (ARS/F-Route)
The number is controlled by ARS/F-
Route table.
Additional Data:
If the ARS/F-Route Time Schedule is
not used, assign the ARS/F-Route table
number for Program 44-05.
If the ARS/F-Route Time Schedule is
used, assign the ARS/F-Route selection
number for Program 44-04.
• Service Type 3 (Dial Extension Analyze
Table)
The total length of the number exceeds
more than 8 digits.
Additional Data:
Assign the Dial Extension Analysis Ta-
ble number to be used in Program
44-03.
0
ISSUE 3.01 SL1000/SL1100
Programming Manual 2-397
Program
44