NEC SL 1000 - Page 420

Item
No.
Item Input Data Description Default
03 Additional Data 1 = Delete Digit = 0 ~
255 (255 = Delete All
Digits)
2 = 0 ~ 100 (0 = No Set-
ting)
3 = Dial Extension Ana-
lyze Table Number = 0 ~
4 (0 = No Setting)
For the Service Type selected in 44-02-02,
enter the additional data required.
• 1 : Delete Digit = 0 ~ 255
(255 = Delete All Digits)
• 2 : [Program 44-01 : 0]
ARS/F-Route Table Number = 0 ~ 100
(0 = No Setting)
Refer to Program 44-05.
[Program 44-01 : 1]
ARS/F-Route Select Table Number = 0
~ 100 (0 = No Setting)
Refer to Program 44-04.
• 3 : Dial Extension Analyze Table Num-
ber = 0 ~ 4 (0 = No Setting)
Refer to Program 44-03.
0
04 Dial Tone Simulation 0 = Off
1 = On
If enabled, this option sends dial tone to
the calling party after the routing is deter-
mined. This may be required if the central
office at the destination does not send dial
tone.
0
Conditions
None
Feature Cross Reference
• Automatic Route Selection (ARS/F-Route)
SL1000/SL1100 ISSUE 3.01
2-398 Program 44 : ARS/F-Route Setup
Program
44