Program 11 : System Numbering
11-09 : Trunk Access Code
Level:
IN
Description
Use Program 11-09 : Trunk Access Code to assign the trunk access code. The trunk access code
can be set from 1 ~ 4 digits which is defined to type 3 and 4 in Program 11-01. This is the code
extension users dial to access Automatic Route Selection (ARS/F-Route). The Individual Trunk
Access Code is used when Trunk Group Routing is desired for an outgoing line.
Caution!
The digit 9 is defined in Program 11-01 as Dial Type ( ) with the Number of Digits Required set to ( ). If you change the
trunk access code in Program 11-09, you must make the corresponding changes in Program 11-01.
Input Data
Item
No.
Item Input Data Description Default Related
Program
01 Trunk Access
Code
Dial (Up to four digits) Use this program to assign the trunk
access code. This is the code exten-
sion users dial to access Automatic
Route Selection (ARS/F-Route).
0 • 11-01 :
System
Num-
bering
• 14-01 ~
07 : Ba-
sic
Trunk
Data
Setup
• 14-05 :
Trunk
Group
• 14-06 :
Trunk
Group
Routing
• 21-02 :
Trunk
Group
Routing
for Ex-
tensions
ISSUE 3.01 SL1000/SL1100
Programming Manual 2-69
Program
11
To Next Page
Loading...
