Program 44 : ARS/F-Route Setup
44-05 : ARS/F-Route Table
Level:
IN
Description
Use Program 44-05 : ARS/F-Route Table to set the ARS/F-Route table. There are four kinds of
order. If the higher priority trunk groups are busy, the next order group is used. If a lower priority route
is selected, the caller may be notified with a beep tone.
Input Data
ARS/F-Route Table Number 001 ~ 100
Priority Number 1 ~ 4
Item
No.
Item Input Data Description Default
01 Trunk Group Number 0 = No Setting
1 ~ 25 = Trunk Group
255 = Extension Call
Select the trunk group number to use for
the outgoing ARS call.
0
02 Delete Digits 0 ~ 255
(255 = Delete All)
Enter the number of digits to be deleted
from the dialed number.
0
03 Additional Dial Num-
ber Table
0 ~ 100 Enter the table number (defined in Pro-
gram 44-06) for additional digits to be di-
aled.
0
04 Beep Tone 0 = Off
1 = On
Select whether or not a beep is heard if a
lower priority trunk group is used to dial
out.
0
05 Gain Table Number
for Internal Calls
0 ~ 100
0 = No setting
Select the gain table number to use for the
internal call (defined in Program 44-07).
0
06 Gain Table Number
for Tandem Connec-
tions
0 ~ 100
0 = No setting
Select the gain table number to use for the
tandem call (defined in Program 44-07).
0
07 ARS Class of Service 0 ~ 16
0 = No ARS Class (Call
Restricted)
Select the ARS Class of Service to use for
the table. An extension ARS COS is deter-
mined in Program 26-04-01.
0
08 Dial Treatment 0 ~ 15 Select the Dial Treatment to use for the ta-
ble. If a Dial Treatment is selected, Pro-
grams 44-05-02 and 44-05-03 are ignored
and the Dial Treatment defined in Program
26-03-01 is used instead.
0
09 Maximum Digit 0 ~ 24 Input the maximum number of digits to
send when using the F-Route.
0
11 Network Specified Pa-
rameter Table
0 ~ 16 Enter a table number from Program 26-12. 0
Conditions
None
SL1000/SL1100
ISSUE 3.01
2-402 Program 44 : ARS/F-Route Setup
Program
44
To Next Page
Loading...
