Program 20 : System Option Setup
20-03 : System Options for Single Line Telephones
Level:
IN
Description
Use Program 20-03 : System Options for Single Line Telephones to set up various options for
single line telephones.
Input Data
Item
No.
Item Input Data Description Default Related
Program
01 SLT Call Waiting
Answer Mode
0 = Hook Flash (Hook-
ing)
1 = Hook Flash + Serv-
ice Code 894
For a busy single line telephone, set
the mode used to answer a camp-
ed-on trunk call.
0 11-12-47
02 Ignore Received
DP Dial on DTMF
SLT Port
0 = Do Not Ignore (No)
1 = Ignore (Yes)
Use this option to define whether
the system should receive dial pulse
and DTMF signals (0) or ignore dial
pulse and only accept DTMF signals
(1).
0 15-03-01
03 SLT DTMF Dial to
Trunk Lines
0 = Receive all dialed
data, before sending
(All)
1 = Direct through out
(Direct)
• Type 0 : The system keeps the
digits dialed by the single line tel-
ephone on a trunk in a buffer. Af-
ter all the digits are received, the
system sends all the digits to the
trunk. If the time space between
digits is longer than the time in
Item 4, the system considers all
digits received.
• Type 1 : The system passes the
received digits from the single line
telephone to the trunk immediate-
ly. If the single line telephone has
a Last Number Dial key without a
pause, this key may not be able to
use the Last Number Dial key with
the Type 1 setting.
When using a third-party external
paging device, set this option to 1.
In addition, set Program 20-03-04 to
1
0 20-03-04
04 Dial Sending
Start Time for
SLT or ARS
0 ~ 64800 seconds When ARS or an analog extension
user accesses a trunk and dials an
outside call, the system waits this
time before outdialing the first digit.
When using a third-party external
paging device, set this option to 1.
In addition, set Program 20-03-03 to
1.
3 20-03-03
05 SLT Operation
Mode
0 = Normal Mode
1 = Extended Mode 1
2 = Extended Mode 2
0
ISSUE 3.01 SL1000/SL1100
Programming Manual 2-179
Program
20
To Next Page
Loading...
