Item
No.
Item Input Data Description Default
11 Incoming Ring Group
Transfer
0 = Disable (Calls will
not be routed to PRG
22-12.)
1 = Enable (Calls will be
routed to PRG 22-12.)
Enable (1) or disable (0) each conversa-
tion tables ability to follow the Ring Group
programming defined in Program
22-12-01 : DID Intercept Ring Group. If
Program 22-11-05 (DID Translation Num-
ber Conversion, Transfer Destination
Number 1) and Program 22-11-06 (DID
Translation Number Conversion, Transfer
Destination Number 2) are set, the priority
of transferring is in this order (Program
22-11-05 then Program 22-11-06) then if
Program 22-11-11 is enabled, the calls will
overflow from Transfer Destination Num-
ber 2 to the destination programmed in
PRG 22-12-01.
If the terminal is in Power Cutting mode
from the ecology feature this command
will not be applied.
1
Default
The default value of Programs 22-11-01 and 22-11-02 is shown as below.
Conversion Table Received number Target number
1 00 200
2 01 201
: : :
100 99 299
: : :
800 No setting No setting
Conditions
When the trunk type is set to 3 (DID) in 22-02-01, the DID Transfer Destination for each DID feature is
not supported. This feature is supported only for DID trunks when assigned as VRS.
Feature Cross Reference
• Direct Inward Dialing (DID)
ISSUE 3.01
SL1000/SL1100
Programming Manual 2-279
Program
22
To Next Page
Loading...
