NETGEAR S3300 - Page 339

Configuration Examples
339
S3300 Smart Managed Pro Switch
Figure 119. VLAN Membership
For more information about how to perform this step, see VLAN Membership Configuration
on page 146.
3. In the Port PVID Conf
iguration screen, specify the PVID for ports g1 and g4 so that packets
entering these ports are tagged with the port VLAN ID:
• Port g1: PVID 10
• Port g4: PVID 20
For more information about how to perform this step, see Port VLAN ID Configuration on
page 148.
With the VLAN configuration that you set up, t
he following situations produce results as
described:
• I
f an untagged packet enters port 1, the switch tags it with VLAN ID 10. The packet has
access to port 2 and port 3. The outgoing packet is stripped of its tag to leave port 2 as an
untagged packet. For port 3, the outgoing packet leaves as a tagged packet with VLAN ID
10.
• I
f a tagged packet with VLAN ID 10 enters port 3, the packet has access to port 1 and port
2. If the packet leaves port 1 or port 2, it is stripped of its tag to leave the switch as an
untagged packet.
• I
f an untagged packet enters port 4, the switch tags it with VLAN ID 20. The packet has
access to port 5 and port 6. The outgoing packet is stripped of its tag to become an
untagged packet as it leaves port 6. For port 5, the outgoing packet leaves as a tagged
packet with VLAN ID 20.