Position the white balance target (r) over a whit
e or
gray object and measure a value for preset manual white
balance.
Position the target (r) using the multi selector.
To measure white balance, press the shutter-release button
all the way down or press J. White balance can be
measured multiple times while direct measurement mode
is in effect.
You can also position the target (r) and measure white
balance by tapping the display.
Target selection will not be available if an optional flash
unit is attached. Frame the shot so that the white or gray
reference object is in the center of the display.
If the camera is unable to measure white balance, a message
will be displayed and the camera will return to direct
measurement mode. Try measuring white balance again, for
example with the target (r) positioned over a different area
of the subject.
Press the i button to exit direct measurement mode.
158
White Balance
4
5
To Next Page
Loading...
