Nikon Z8 - Page 475

f: Establish a wireless connection between the WR‑R11a/WR‑R10 and the remote flash
units.
Set the remote units to radio AWL remote mode.
Set the remote units to the channel you selected for the WR‑R11a/WR‑R10 in Step 3.
Pair each of the remote units with the WR‑R11a/WR‑R10 according to the option selected in
Step4:
[Pairing]: Initiate pairing on the remote unit and press the WR‑R11a/WR‑R10 pairing
button. Pairing is complete when the LINK lamps on the WR‑R11a/WR‑R10 and flash unit
flash orange and green. Once a connection is established, the LINK lamp on the remote
flash unit will light green.
[PIN]: Use the controls on the remote flash unit to enter the PIN you selected in the
previous step. Pairing begins when the PIN is entered. Once a connection is established,
the LINK lamp on the remote flash unit will light green.
f: Repeat Step5 for the remaining remote units.
f: Confirm that the flash-ready lights for all flash units are lit.
In radio AWL, the flash-ready indicator will light in the camera shooting display when all flash
units are ready.
401
Radio AWL
5
-
-
6
7