Alert
Problem/solution
Camera display Control panel
(Exposure indicators and shutter speed or
apertur
e display flash)
Subject too bright; limits of camera exposure
metering system exceeded.
Lower ISO sensitivity.
Mode P: Use third-party ND (neutral density) filter
(filter can also be used if alert is still displayed
after following settings are adjusted in mode S or
A).
Mode S: Choose faster shutter speed.
Mode A: Choose smaller aperture (higher
f‑number).
Subject too dark; limits of camera exposure
metering system exceeded.
Increase ISO sensitivity.
Mode P: Use optional flash unit (flash can also
be used if alert is still displayed after following
settings are adjusted in mode S or A).
Mode S: Choose slower shutter speed.
Mode A: Choose wider aperture (lower f‑number).
c (flashes)
—
Flash has fired at full power.
Photo may be underexposed. Check distance to
subject and settings such as aperture, flash range,
and ISO sensitivity.
Full (flashes)
Memory insufficient to record further photos.
Delete pictures from memory card until there is
room for additional pictures to be recorded. Copy
pictures you wish to keep to computer or other
device before proceeding.
Insert new memory card.
Camera has run out of file numbers.
Delete pictures from memory card until there is
room for additional pictures to be recorded. Copy
pictures you wish to keep to computer or other
device before proceeding.
Insert new memory card.
811
Alerts and Error Messages
To Next Page
Loading...
