Notifier AFP-200 Installation Manual

Installation Wiring a Signaling Line Circuit (SLC)
52 AFP-200 PN 15511:H2 10/14/2002
Wiring an NFPA Style B IDC with Standard Monitor Modules
Figure 34 shows typical wiring using FMM-1 modules to wire a Style B IDC.
Maximum IDC resistance is 20 ohms. Refer to Device Compatibility Document for
detector and power supervision relays.
Figure 34 Typical Style B (Class B) IDC Wiring with FMM-1 Modules
TB4
TB5 TB6
TX REF RX REF
OUT O UT IN IN
1 2 3 4 5 6
A B B+ A+ B- A-
TB1
TB2 TB3
+ - + - + -
B+ B- B+ B- B+ B- B+ B- NO C NO NC C NO NC C
+
+
-
-
+
+
-
-
+
+
-
-
+
+
-
-
90
81
72
63
54
-
+
+
-
- +
UL-listed power supervision
relay (shown energized)
To next device
on the SLC
Manual pull station
Heat detector
24 VDC four-wire
smoke detector
24 VDC four-wire detector resettable power:
24 VDC (+) TB1-5
24 VDC (–) TB1-6
SLC out
SLC (+) TB6-3
SLC (–) TB6-5
End-of-Line Resistor
47K, 1/2-watt
PN SSD A2143-00
(N-ELR in Canada)
afp200-IDC-B-FMM1.cdr
CPU
Technical Manuals Online! - http://www.tech-man.com

Notifier AFP-200 Specifications

General

Control Panel Type	Addressable Fire Alarm Control Panel
Auxiliary Power Output	24 VDC, 500 mA
Operating Temperature	32°F to 120°F (0°C to 49°C)
Display	80-character LCD
Power Supply	120 VAC, 60 Hz
Capacity	198 addressable devices
Notification Appliance Circuits	2
Relay Contacts	3 (Form-C)
Relative Humidity	93% non-condensing