Configure the sleep mode timer
Introduction
If the printer is idle for a defined period it goes into sleep mode. In sleep mode the
printer uses minimal energy, because the power supply of the printer is turned off. The
power supply of the embedded controller remains on.
The printer enters the sleep mode when the sleep mode timer expires.
You cannot disable the sleep mode, but you can adjust the value of the sleep mode timer
(default value is 60 minutes).
How to configure the time-out value of the sleep mode timer
1.
Click 'Preferences' - 'System settings'.
2.
Click 'Edit' in the 'Printer properties' bar or click the value of the 'Sleep mode timeout'
setting.
3.
Enter a new value in the Edit window and click 'Ok' to confirm your entries or 'Cancel'
to reject your entries.
Note:
If you access the Edit window by clicking the value of the setting you want to change,
the Edit window displays the minimal and maximal value you can select.
Note:
When the printer is in sleep mode, there are several ways to activate the system.
•
send a print job.
•
insert a USB mass storage device
•
feed a cut sheet media.
•
press a button on the user panel.
•
open a media drawer
Chapter 4 - Define your workflow with the Océ Express WebTools 137
Configure the sleep mode timer
To Next Page
Loading...
Need help?
General
