Make multiple sets of copies
Introduction
You can use the 'Create set' option to make multiple sets of copies.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the de-
fault value for that setting in the Océ Express WebTools.
After you press the start key, the user panel always shows the job number and status of
the job. A copy job appears temporarily in the 'Jobs - Queue' section of the Océ Express
WebTools, a scan job appears in the Smart Inbox 'Scans'.
How to make multiple sets of copies sorted by set
1.
Feed the original face up and centered on the original feeding table.
Note:
You do not need to center the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
The 'Copy' tab is automatically activated on the user panel.
2.
Open the 'Copy' tab with the confirmation button above the scroll wheel.
3.
Define the job settings.
•
Open a template with the confirmation button.
The 'Create set' option appears at the lower left corner of the screen.
•
Select 'Create set' with the lower left soft key.
The 'Close set' option appears at the lower left corner of the screen.
•
Scroll to 'Sort', define 'By set' and confirm with the with confirmation button. This
setting is disabled after you press the green button for the first time.
•
Press'OK'.
•
Change the settings for your first original if necessary.
•
Define the number of copies and press the green button.
You can not change the number of copies after you press the green button for the first
time.
Chapter 5 - Use the printing system232
Make multiple sets of copies
To Next Page
Loading...
Need help?
General
