Oce PlotWave 350 - Move and Re-Adjust the Printing System; The Main

Move and re-adjust the printing system
Introduction
When you move the printing system to a new location you must check if it needs re-ad-
justment to ensure the best output quality.
You need two tools for the adjustment procedure. You can find these tools behind the
lower right front cover (11).
8
1
2
3
4
9
10
11
12
6 75
Required tool
•
Allen wrench
•
Key wrench
Attention:
If connected you must first switch off and disconnect the Océ PlotWave 350. (see ‘Switch
off the printing system’ on page 278 and ‘Disconnect the network cable and the mains supply
cable’ on page 280).
Chapter 6 - Maintain the printing system 281
Move and re-adjust the printing system