Oce PlotWave 350 - Initial Setup and Connections

Connect the mains supply cable and the network cable
Attention:
Make sure the green power switch(B) is in 'off' position.
1.
Plug in the mains supply cable at the power connection at the back of the printer (A) (on
the left).
A
B
2.
Plug the other side of the mains supply cable into the wall socket.
3.
Plug in the network cable at the bottom network connection at the back of the printer
(at the right) to connect the Océ PlotWave 350 to your company network.
Chapter 3 - Quick start48
Connect the mains supply cable and the network cable