Available settings for scan jobs
Introduction
The Océ PlotWave 350 provides a lot of settings to manage all your different scan jobs.
These settings are used for extended scan jobs. The following table gives an overview and
a very short description of the available settings. You can find a detailed description of
each setting in the Océ Express WebTools.
Settings group: 'Destination'
#
FunctionSettings valuesSetting
'The destination to put the scans into.'
(see ‘Configure a local scan destination’ on
page 141)
You can select one of
the names of the scan
destinations that you
configured in the Océ
Express WebTools.
'Destination'
Settings group: 'File type'
#
FunctionSettings valuesSetting
Note:
Depending on the color mode and file type you select the values for the
compression mode and organization will change. For some file types, the
compression and organization settings cannot be set in all situations. (see also
‘'File type' ’ on page 269)
Chapter 5 - Use the printing system 263
Available settings for scan jobs
To Next Page
Loading...
Need help?
General
