Make a half size copy (50%) of a CAD drawing
Introduction
This template allows you to make a copy for which both the length and the width of the
original file will be reduced by 50%.
As a result, for example, an original file of A0 format will produce an A2 format copy.
Make a half size copy
1.
Feed the original face up and centered on the original feeding table.
Note:
You do not need to center the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
Chapter 3 - Quick start 87
Make a half size copy (50%) of a CAD drawing
To Next Page
Loading...
Need help?
General
