Make a copy of a specific area of an original
Introduction
You can make a copy of a specific area of an original with the 'Remove strip' setting.
Define the following strips to specify the area.
•
'Top'
•
'Bottom'
•
'Left'
•
'Right'
Before you begin
If you must enter the same value for a setting very often, you can set this value as the de-
fault value for that setting in the Océ Express WebTools.
After you press the start key, the user panel always shows the job number and status of
the job. A copy job appears temporarily in the 'Jobs - Queue' section of the Océ Express
WebTools, a scan job appears in the Smart Inbox 'Scans'.
Attention:
When you erase a margin, make sure that you copied all the required information.
How to copy a specific area of an original
1.
Feed the original face up and centered on the original feeding table.
Note:
You do not need to center the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
The 'Copy' tab is automatically activated on the user panel.
2.
Open the 'Copy' tab with the confirmation button above the scroll wheel.
3.
Define the job settings.
#
Chapter 5 - Use the printing system 243
Make a copy of a specific area of an original
To Next Page
Loading...
Need help?
General
