Before making copies
2
d-Color MF25 2-47
9 Push down the left and right release
levers M2 to the position.
10 Close the fusing unit cover.
11 Close the upper right-side door.
– After printing envelopes, return the left and right M2 release levers
to their center positions.
!
Detail
When loading paper exceeding A3 size into the 1st tray, the paper can
have a width up to 311.1 mm and a length up to 457.2 mm.
For details on specifying the paper size for the 1st tray, refer to “To spec-
ify a paper size (set size settings)” on page 7-11.
2
Reminder
Be careful not to touch the surface of the paper take-up roller with your
hands.
If the lateral guides are not positioned correctly for the loaded paper, the
paper size will not be correctly detected. Be sure to adjust the lateral
guides to the size of the loaded paper.
Before loading envelopes, press them down to make sure that all air is
removed, and make sure that the folds of the flaps are firmly pressed,
otherwise the envelopes may become wrinkled or a paper misfeed may
occur.
To Next Page
Loading...
Need help?
General