E5EK
5--37
• The parameters in this mode can be used only when the “security” parameter
(protect mode) is set to “0” and “1”.
• You can select this mode only when the option unit is set in the controller. In this
mode, you can set the communications conditions, transfer output and event input
parameters to match the type of option unit set in the controller.
• To select this mode when in the levels 0 to 2, setup, expansion and calibration
modes, press the
key for 1 second minimum. The display changes to the menu
display. If you select [
]usingthe key then press the key for 1
second minimum, the controller enters the option mode.
• To select parameters in this mode, press the
key. To change parameter set-
tings, use the
or keys.
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
Symbol Paramete r Name Page
Multi-SP function 5-38
Event input assignment 1 5-39
Event input assignment 2 5-39
Communication stop bit 5-40
Communication data length 5-40
Communication parity 5-40
Communication baud rate 5-40
Communication unit No. 5-40
Transfer output type 5-41
Transfer output upper limit 5-41
Transfer output lower limit 5-41
HBA latch 5-42
Motor calibration 5-42
Travel time 5-43
PV dead band 5-43
Remote SP enable 5-44
Remote SP upper limit 5-44
Remote SP lower limit 5-44
SP tracking 5-45
Option Mode
To Next Page
Loading...
Need help?
General
