Omron E5EK User Manual

1.3 Parameters and Menus
E5EK
1--9
• If you select [
][ ][ ]or[ ]inthe menudisplay,
the setup, expansion, option and calibration modes, respectively, are
selected.
• When these modes are selected, the control is reset. So, control out-
puts and auxiliary output are turned OFF. When another mode is
selected while in these modes, reset is canceled.
• To set the controller to the protect mode or to return to the level 0
mode from the protect mode, press the
A/M
key and key for 1 se-
cond minimum simultaneously.
• To set the controller to the manual mode, press the
A/M key for 1 se-
cond minimum in the level 0 to 2 mode. To return to the level 0 mode
from the manual mode, press the
A/M key for 1 second minimum.
• When not in the manual mode, each press of the
key switches the
parameter.
• If you press the
key when at the final parameter, the display re-
turns to the first parameter.
Parameter
1
Parameter
2
Parameter
3
Parameter
n
• When you have changed a parameter setting, specify the parameter
using the
or keys, and either leave the setting for at least two
seconds or press the
key. This fixes the setting.
• When another mode is selected, the content of the parameters before
the mode was selected is fixed.
• When turning the power OFF, you must first fix the settings and
parameter contents (by pressing the
key or selecting another
mode). The settings and parameter contents are sometimes not
changed by merely pressing the
or keys.
F Setup mode
F Expansion mode
F Option mode
F Calibration mode
F Protect mode
F Manual mode
JSelecting
parameters
JFixing settings

Omron E5EK Specifications

General

Brand	Omron
Model	E5EK
Category	Controller
Language	English