Omron E5EK - Alarm value 1; Alarm value 2; Alarm value 3

CHAPTER 5 PARAMETERS
E5EK
5--12
Setting Range
Unit Default
Set point lower limit to Set point upper limit EU 0
F Related article
4.3 How to Use Event Input (page 4-8)
F Related parameters
“Multi-SP function” “Remote SP enable” (option mode)
“Set point” (level 0 mode) “SP mode” (level 2 mode)
“Input type” “Scaling upper limit” “Scaling lower limit” “Decimal point” (setup
mode)
F Option unit
E53-AKB
Alarm value 1
Alarm value 2
Alarm value 3
Conditions of Use
Alarms must be assigned as outputs. For
example, if alarm outputs 1 and 2 only are
assigned as outputs, the “alarm value 3”
parameter cannot be used.
• This parame t er is us ed for monitoring or changing the alarm value s of alarm outpu ts
1to3.
• During temperature input, the decimal point position is dependent on the cur-
rently selected sensor, and during analog input on the results of scaling.
Setting Range
Unit Default
-1999 to 9999 EU 0
F Related article
3.4 Setting Alarm Type (page 3-9)
F Related parameters
“Input type” “Scaling upper limit” “Scaling lower limit” Decimal point” “Control
output 1 assignment” “Control output 2 assignment” “Auxiliary output 1 assign-
ment” “Auxiliary output 2 assignment” “Alarm 1 type” “Alarm 2 type” “Alarm 3
type” “Alarm 1 open in alarm” “Alarm 2 open in alarm” “Alarm 3 open in alarm”
(setup mode)
“Alarm 1 hysteresis” “Alarm 2 hysteresis” “Alarm 3 hysteresis” (level 2 mode)
“Standby sequence reset method” (expansion mode)
Level 1 Mode
Comment
See
Model
Function
Comment
See