CHAPTER 4 APPLIED OPERATIO N
E5EK
4--1
CHAPTER 4
APPLIED OPERATION
This chapter describes each of the parameters required for making
full use of the features of the E5EK. R ead this chapter while referring
to the parameter descriptions in chapter 5.
CHAPTER4
4.1 Selecting the Control Method 4-2............
Heating and cooling control 4-2.............
Position-proportional control 4 -3............
ON/OFF control 4-4.......................
4.2 Operating Condition Restrictions 4-5........
Manipulated variable restrictions 4-5........
Set point limiter 4-6.......................
SP ramp 4-6..............................
4.3 How to Use Event Input 4-8................
Input assignments 4-8.....................
Multi-SP 4-9..............................
Other event input functions 4-10.............
4.4 How to Use the Remote SP 4-11..............
Scaling 4-11................................
SP mode 4-11..............................
Remote SP monitor 4-12....................
SP tracking 4-12............................
Operating conditions 4-12...................
4.5 How to Use the Heater Burnout Alarm 4-13...
Heater burnout detection 4-13...............
Operating conditions 4-13...................
How to calculate
the heater burnout set value 4-14............
4.6 LBA 4-15..................................
4.7 How to Use Transfer Output 4-17............
To Next Page
Loading...
Need help?
General
