Omron E5EK User Manual

E5EK
5--19
Remote/Local
Conditions of Use
The communications function must be in
use.
• Switches between remote and local operation.
• To change the parameter setting during remote operation, use the communi ca-
tions function. To change the parameter setting during local operation, change the
setting on the E5EK controller.
You can check the parameter setting by both communications and on the E5EK
controller regardless of whether the controller is switched to remote or local
operation.
Setting Range
Default
[ ]: remote / [ ]: local
[]
F Related article
Chapter 6 Using the Communications Function
F Related parameters
“Communication stop bit” “Communication data length” “Communication par-
ity” “Communication baud rate” “Communication unit No.” “Event input assign-
ment 1” “Event input assignment 2” (option mode)
F Option units
E53-AK01/02/03
SP mode
Conditions of Use
The remote SP function must be
enabled and ST must be set to OFF.
• Switches between remote SP and local SP.
• Switches the SP to the remote SP when an event input to which the “SP mode”
has been assigned is ON. Switches the SP to the local SP when an event input to
which the “SP mode” has been assigned is OFF.
Setting Range Default
[ ]: Remote SP/[ ]: Local SP
F Related article
4.4 How to Use the Remote SP (page 4-11)
F Related parameters
“Remote SP enable”
“Event input assignment 1” “Event input assignment 2” “Event input assignment
3” “Event input assignment 4” (option mode)
Level 2 Mode
Function
Comment
See
Model
Function
Comment
See

Omron E5EK Specifications

General

Brand	Omron
Model	E5EK
Category	Controller
Language	English