Omron E5EK User Manual

CHAPTER 5 PARAMETERS
E5EK
5--46
• The parameters in this mode can be used only when the “security” parameter
(protect mode) is set to “0”. When selecting this mode for the first time after the
E5EK has left the factory, return the “security” parameter to “0”.
• This mode contains the parameters for user calibration of inputs and outputs.
Only parameters relating to input types specified in the “input type” parameter
(setup mode) can be used. Also, related output parameters can be used only when
the communications unit (E53-AKF) is added on.
• To select this mode when in the levels 0 to 2, setup, expansion and option modes,
press the
key for 1 second minimum. The display changes to the menu dis-
play. If you select [ ]usingthe key then press the key for 1 se-
cond minimum, the controller enters the calibration mode.
• For details on parameters in the calibration mode, see Chapter 7 Calibration.
Calibration Mode

Omron E5EK Specifications

General

Brand	Omron
Model	E5EK
Category	Controller
Language	English