Omron E5EK - Page 175

E5EK
Revision History
A manual revision code appears as a suffix to the catalog number on the front cover of the manual.
Cat. No. H085-E1-03
Revision code
The following table outlines the changes made to the manual during each revision. Page numbers
refer to previous version.
Revision code Date Revised content
1 July 1996 Original production
2 April 1997
Page V: Changed “100 to 240 VAC” to AC100--240V or AC/DC24V
Page 1--6: Modified the item of “Model” on the table.
Page 2--8: Modified the diagram in “Terminal arrangement”.
Changed the power specifications in Power supply”.
Page 2--10: Deleted some texts in “CT input/Potentionmeter”.
Changed some texts in ”Remote SP input”.
Page 3--3: Modified the diagram in ”Setup”.
Page 3--8: Added “run/stop” = “run” to Setting Example.
Page 5--8: Added “Model” and “Power specifications” to MV monitor.
Page 5--9: Added “Model” and “Power specifications” to Valve opening mon-
itor.
Page 5--13: Added “Model” and “Power specifications” to Cooling coefficient.
Page 5--14: Added “Model” and “Power specifications” to Dead band.
Added “Model” and “Power specifications” to Position--propor-
tional dead band.
Page 5--15: Added “Model” and “Power specifications” to Manual reset value.
Added “Model” and “Power specifications” to Hysteresis.
Page 5--16: Added “Model” and “Power specifications” to Control period.
Page 5--17: Added “Model” and “Power specifications” to Heater current
monitor .
Added “Model” and “Power specifications” to Heater burnout.
Page 5--23: Added “Model” and “Power specifications” to Open/close hyster-
esis Model.
Page 5--28: Added “Model” and “Power specifications” to Control output as-
signment.
Page 5--33: Added “Model” and “Power specifications” to PID/ON/OFF.
Page 5--42: Added “Model” and “Power specifications” to HBA latch.
Added “Model” and “Power specifications” to Motor Calibration.
Page 5--43: Added “Model” and “Power specifications” to Travel Time.
Added “Model” and “Power specifications” to PV dead band.
Page 6--3: Modified the diagram in “RS--232C”.
Page 7--4: Modified the diagram in “Preparations”.
Page 7--7: Modified the diagram in “Preparation”.
Page 7--9: Modified the diagram in “Preparation”.
Page 7--10: Modified the diagram in “Preparation”.
Page 7--12: Modified the diagram in “Thermocouple”.
Modified the diagram in “Platinum resistance thermometer”.
Page 7--13: Modified the diagram in “Current input”.
Modified the diagram in “Voltage input”.
Page 8--4: Added “Motor calibration error”.
Page A--2: Modified “Ratings specifications”.
Page A--1 1: Changed “Type Name” and “Specification” in Base unit.
Page A--14: Deleted 2) of “At the time the E5EK starts operation” in “Startup
Conditions of SRT”.
Deleted 2) of “At the time set point is changed”.
Page A--15: Deleted “Imposition Completion Condition of Step Control
Amount”.
Modified the diagram in “PID Constant Refreshing Conditions”.
~
02A March 2005 Page A--3: Added information to table and accompanying notes.
03 June 2010 Page A--8: Changed ”%” or ”%FS” for hysteresis parameters at bottom of
table.