Omron NS

Section 5 Troubleshooting and Maintenance 5-2 Error Messages
5-27
NS Series Programming Manual
Errors Suggested cause as displayed Possible countermeasure
Exception error during process-
ing. (SRES:05)
System program corrupted. Download the system
program. If the error persists, contact your nearest
OMRON representative.
Incorrect element type
(SRES:13).
Screen data corrupted. Download screen data.
Incorrect start address.
(SRES:1A)
Address outside range has been set. Check the set-
ting data and use CX-Designer to correct the setting.
PT
memory
error
(MRES:7F)
Insufficient read data buffer
(SRES:1B).
System program corrupted. Download the system
program. If the error persists, the PT may need re-
paired. Contact your nearest OMRON representative.
Standby processing failed for
exclusive processing.
(SRES:1C)
System program corrupted. Download the system
program. If the error persists, the PT may need re-
paired. Contact your nearest OMRON representative.
Insufficient write data elements.
(SRES:1D)
System program corrupted. Download the system
program. If the error persists, the PT may need re-
paired. Contact your nearest OMRON representative.
Incorrect end address.
(SRES:2B)
Address outside range has been set. Check the set-
ting data and use CX-Designer to correct the setting.
Access method initialization fail-
ure (SRES:3C).
System program corrupted. Download the system
program. If the error persists, the PT may need re-
paired. Contact your nearest OMRON representative.
Access method exit processing
failure (SRES:3D).
System program corrupted. Download the system
program. If the error persists, the PT may need re-
paired. Contact your nearest OMRON representative.
Incorrect Access Method pa-
rameters (SRES:3E).
System program corrupted. Download the system
program. If the error persists, the PT may need re-
paired. Contact your nearest OMRON representative.
Other incorrect subresponse
code.
The PT may need repaired. Contact your nearest
OMRON representative.