Section 5 Troubleshooting and Maintenance 5-2 Error Messages
5-29
NS Series Programming Manual
The following information is displayed under macro execution timing.
Macro execution timing Details
When loading a project Macro executed when project loaded.
Alarm/Event ON Macro executed when alarm or event ON.
Alarm/Event OFF Macro executed when alarm or event cleared.
When loading a screen Macro executed when screen opened.
When unloading a screen Macro executed when screen closed.
Touch ON Macro executed when ON/OFF, Word, or Command Buttons touched ON.
Touch OFF Macro executed when ON/OFF, Word, or Command Buttons touched OFF.
Before Inputting numeral and
string
Macro executed when numeral display and input or string display and input
objects touched.
Before writing numeral and
string
Macro executed when input made to numeral display and input or string
display and input objects or thumbwheel switches.
When changing numeral or
string
Macro executed when contents of address set to a bit lamp, word lamp,
numeral display and input object, string display or input object, or thumb-
wheel switch are changed.
When selecting a list Macro executed when selection made from list selection.
Macro executed when alarm or event display area is pressed during an
alarm or event.
When Pressing a Display Area A
Macro executed when displayed alarm/event selected using alarm/event
summary and history object.
N
N
N
o
o
o
t
t
t
e
e
e
♦
A communications error message will also be displayed if an illegal address is accessed by a
macro.
To Next Page
Loading...
Need help?
General
