6-91
D Parameter Settings
The
following table shows the setting information for the multi-function outputs. These parameters
can
-
not be changed during operation.
Parameter Display name Setting Units Default
range setting
*1
V/f
Control
V/f with
PG
Open Loop
Vector
Flux
Vector
H2-01 Terminal 9 Sel 0 to 37 --- 0 Basic or Advanced
H2-02 Terminal 25 Sel 0 to 37 --- 1 Basic or Advanced
H2-03 Terminal 26 Sel 0 to 37 --- 2 Basic or Advanced
Note 1. The
following table shows the settings and page references for
functions that are described in
more detail in this chapter.
Function Setting Page
Fref/Fout Agree 1 2 6-104
Fref/Set Agree 1 3 6-104
Frequency Detection 1 4 6-104
Frequency Detection 2 5 6-104
Torque Detection 1 (N.O.) B 6-108
Loss of Reference C 6-104
Timer Output 12 6-46
Fref/Fout Agree 2 13 6-104
Fref/Set Agree 2 14 6-104
Frequency Detection 3 15 6-104
Frequency Detection 4 16 6-104
Torque Detection 1 (N.C.) 17 6-108
Torque Detection 2 (N.O.) 18 6-108
Torque Detection 2 (N.C.) 19 6-108
Motor Selection 1C 6-70
Note 2. The following table shows the settings for simple functions that aren’t explained in detail.
Function Setting
Inverter Ready 6
DC Bus Undervoltage 7
Baseblock 1 8
Option Reference 9
Remote Operation A
DB overheat D
Fault E
Minor Fault 10
Reset Command Active 11
Reverse Direction 1A
Baseblock 2 1B
Motor 2 Selected 1D
Regenerating 1E
Current/Torque Limit 30
Speed Limit 31
Advanced Operation Chapter
6
To Next Page
Loading...
