R-1
Revision History
A manual revision code appears as a suffix to the catalog number on the front cover of the manual.
Cat. No. I516-E1-04
Revision code
The following table outlines the changes made to the manual during each revision. Page numbers refer to the
previous version.
Revision
code
Date Revised content
1 September
1996
Original production
2
April 1997
The following constant numbers were added to Section 7: b1-07, C3-05, C5-08, C8-30, E1-1
1, E1-12,
E1-13, F1-14, F8-01, H5-05
Page
1-2:
Inverter model list updated. “3-phase” added.
Page 1-5:
Low noise and harmonic countermeasure information clarified.
Page 2-5:
Dimensions added for the new models.
Pages 2-12 and 2-13:
T
erminals and connections changed for the 200-V Class and 400-V Class tables. Notes
added. New models reflected.
Pages 2-16, 2-17, 2-19, and 2-20:
New models added.
Page 2-21: New wire sizes and tightening torque added.
Page 2-23:
New models reflected in the information for wiring the power terminal of the Inverter
.
Pages 2-26 and 2-29:
Note added.
Page 2-31:
New models reflected in the bottom output diagram.
Page 3-29:
Motor selection explanation corrected.
Pages 5-19 and 5-34:
Motor selection information corrected.
Page 5-26: New models reflected in the V/f patterns.
Page 5-27:
Note 2 reference removed from E1-07 in the table. New models reflected in Note 3.
Page 5-42: New models reflected in Note 2.
Page 6-50:
Setting the Carrier Frequency and Inverter Overload “OL2”
information added.
Pages 6-50 and 6-51:
Note references added to the carrier frequency table. Following note rewritten.
Page 6-58:
Setting 16 (Motor 2 Selection) added to the table.
Page 6-70: Settings 1C to 1E corrected and added to.
Page 6-79:
Inverter model corrected for each Note 2.
Page 7-16: Note references added to the carrier frequency table. Following notes rewritten.
Page 7-24:
Motor 2 Setup: E3 to E5
list added.
Pages 7-26 and 7-27:
F9 constant numbers added.
Pages 7-29 and 7-31: Setting values 16 and 1C (motor 2 selection and motor 2 selected) added.
Pages 8-4 and 8-7:
High carrier frequency information added to OH and OL2 fault displays and OH minor fault
display.
Page 8-17:
Inverter overload information added.
Pages 9-2 to 9-4: Specifications completely updated.
Page 9-1
1:
“Control Unit” corrected to “Braking Unit.”
Pages 9-11 and 9-13:
New models added.
Pages 9-21 and 9-23: Noise Filter models added.
Page 10-5: New models added.
To Next Page
Loading...
Need help?
General