Omron SYSDRIVE 3G3FV

3-4
• Press the Escape Key to return to the mode display from the parameter display.
All modes/parameters status
• Operation mode
• Initialize mode
• Programming mode
• Auto-tuning
mode (see note 1)
• Modified constants mode
Monitor (Frequency reference value)
Display parameters changed from
factory settings
Operator display language selection
Frequency reference input method
selection (see note 2)
Auto-tuning (Rated voltage setting)
Power ON
** Main Menu **
Operation
Frequency Ref
U1-01= 60.00 HZ
** Main Menu **
Initialize
** Main Menu **
Programming
** Main Menu **
Auto-Tuning
** Main Menu **
Modified Consts
Reference Source
Operator
Rated Voltage
200.0 VAC
Reference 1
d1-01= 60.00 HZ
Select Language
English
Note 1. Auto-tuning mode will be displayed only when vector control mode has been selected. (The
factory setting is for open-loop vector control.)
Note 2. The actual display depends on the parameter access level setting (A1-01).
Preparing for Operation Chapter 3