Omron SYSDRIVE 3G3MV SERIES - Page 318

10-16
Para
me-
ter
No.
Reg-
ister
No.
(Hex)
Name Description Set-
ting
range
Unit
of
set-
ting
Defaul
t set-
ting
Chan-
ges dur-
ing
opera-
tion
Ref-
er-
ence
page
8 Undertor-
que being
monitored
(NO con-
tact output)
Output if either of the
following parameter
conditions is satisfied.
n117: Undertorque
detection function
selection
n097: Overtorque
detection function
selection 2
n118: Undertorque
9 Undertor-
que being
monitored
(NC contact
output)
n118: Undertorque
detection level
n119: Undertorque
detection time
* NO contact: ON
with undertorque
being detected
NC contact: OFF
with undertorque
being detected
10 Warning
output
ON: Warning being
detected (Nonfatal
error being detected)
11 Base block
in progress
ON: Base block in
progress (in operation
with output turned
OFF)
12 RUN mode ON: Local mode (with
the Digital Operator)
List of Parameters Chapter 10