Reseat a CMIOU
4.
Close the outer shipping container and seal it with the packaging tape supplied
by Oracle.
Related Information
■
“Reseat a CMIOU” on page 101
■
“Install a CMIOU” on page 102
Reseat a CMIOU
Some component replacement tasks (for example, those for interconnects and PDECBS) require
you to unseat a CMIOU before you perform them. After completing those tasks, you need to
reseat the CMIOU.
1.
Slide the CMIOU back into the server until the levers begin to engage.
2.
Press the levers back together toward the center of the CMIOU, and then press
the levers firmly against the CMIOU to fully seat it into the server.
The levers should click into place when the module is fully seated in the server.
Servicing CMIOUs 101
To Next Page
Loading...
Need help?
General