Tools Needed for Service
■
Remove power from the server before servicing any of the components that are inside the
chassis.
■
Ensure that the voltage and frequency of your power source match the voltage and
frequency inscribed on the equipment's electrical rating label.
■
Follow the ESD safety practices as described in “Prevent ESD Damage” on page 61.
Safety Symbols
Note the meanings of the following symbols that might appear in this document:
Caution - There is a risk of personal injury or equipment damage. To avoid personal injury and
equipment damage, follow the instructions.
Caution - Hot surface. Avoid contact. Surfaces are hot and might cause personal injury if
touched.
Caution - Hazardous voltages are present. To reduce the risk of electric shock and danger to
personal health, follow the instructions.
Related Information
■
“Removing Power From the Server or Domain” on page 69
■
“Tools Needed for Service” on page 58
Tools Needed for Service
You will need the following tools for most service operations:
■
Antistatic wrist strap
■
Grounded antistatic mat large enough for the component to be serviced
■
No. 2 Phillips and flathead screwdrivers
■
T8, T10, T20, and T25 Torx wrench key, wrench, or driver
■
Mechanical lift (for some service procedures if only one person is present)
58 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
To Next Page
Loading...
