Switch Unit LEDs
■
“Understanding Server Configurations and Failover Behavior” on page 79
Switch Unit LEDs
No. LED Icon Description
1 Ready to Remove (blue) Indicates that a switch unit can be removed during a hot-service
operation.
2 Service Required LED
(amber)
Indicates that service is required.
The fmadm faulty command provides details about any faults that
cause this indicator to light.
Under some fault conditions, individual component fault LEDs are
illuminated in addition to the Service Required LED.
3 OK LED (green) Indicates these conditions:
■ Off – System is not running in its normal state. System power
might be off. The SP might be running.
■ Steady on – System is powered on and is running in its normal
operating state. No service actions are required.
190 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
To Next Page
Loading...
Need help?
General