Oracle SPARC M8 - Install a PDECB

Install a PDECB
Install a PDECB
1.
Slide the new PDECB into the empty slot.
2.
Install the removed component.
See “Install a CMIOU” on page 102 or “Install a Switch Unit” on page 197.
3.
Verify that the fault has been cleared and the replaced component is operational.
See “Verify That a Fault Has Been Cleared” on page 54.
4.
Return the replaced component to Oracle.
See “Prepare a Component for Return to Oracle” on page 64.
Related Information
■
“Remove a PDECB” on page 200
202 SPARC M8 and SPARC M7 Servers Service Manual • September 2017