Identify Disabled Components
/SYS/CMIOU0/CM/CMP/BOB31/CH0/DIMM | type | DIMM
/SYS/CMIOU0/CM/CMP/BOB31/CH0/DIMM | requested_config_state | Enabled
/SYS/CMIOU0/CM/CMP/BOB31/CH0/DIMM | current_config_state | Disabled
/SYS/CMIOU0/CM/CMP/BOB31/CH0/DIMM | disable_reason | Configuration Rules
/SYS/CMIOU0/CM/CMP/BOB31/CH0/DIMM | fru_name | 16384MB DDR4 SDRAM DIMM
...
Related Information
■
“Component Oracle ILOM State Properties” on page 39
■
“Log In to Oracle ILOM (Service)” on page 67
■
“Clear a Fault Manually” on page 55
■
“Component Names Displayed by Diagnostic Software” on page 40
Component Oracle ILOM State Properties
The following table defines the Oracle ILOM properties seen when using the Oracle ILOM
show command.
Oracle ILOM Property Definition
requested_config_state Property can be Enabled or Disabled. When Enabled, the component is
installed and accessible by the server. When Disabled, the component is
installed, but the server cannot access it.
current_config_state Property can be Enabled, Disabled, or Degraded.
When Enabled, the component is installed and accessible by the server. When
Disabled, the component is installed, but the server cannot access it. When
Degraded, the component has faulted and requires service.
fault_state Property can be OK or Faulted. The property will display OK when the
component is working properly. When Faulted, the component has faulted
and requires service.
clear_fault_action Legacy property previously used to clear component faults. Use the fmadm
acquit from the Oracle ILOM fault management shell to clear component
faults. See “Clear a Fault Manually” on page 55.
Related Information
■
“Identify Disabled Components” on page 38
■
“Component Names Displayed by Diagnostic Software” on page 40
■
“Component Service Task Reference” on page 32
Detecting and Managing Faults 39
To Next Page
Loading...
Need help?
General