Servicing eUSB Disks
A single eUSB disk is installed in each CMIOU in the server. For the location of the eUSB
disks inside a CMIOU, see “DIMM and eUSB Locations in a CMIOU” on page 27.
Caution - This procedure requires that you handle components that are sensitive to electrostatic
discharge. This discharge can cause server components to fail. Follow antistatic precautions to
prevent electrostatic damage. See “Prevent ESD Damage” on page 61.
These topics explain how to service the eUSB disks in the CMIOUs.
Step Description Links
1. Remove the CMIOU so that you can replace an eUSB
disk.
“Servicing CMIOUs” on page 83
2. Replace an eUSB disk. “Remove an eUSB Disk” on page 203
“Install an eUSB Disk” on page 205
3. Install the CMIOU after you have replaced the eUSB
disk.
“Install a CMIOU” on page 102
Related Information
■
“Identifying Components” on page 15
■
“Detecting and Managing Faults” on page 35
■
“Preparing for Service” on page 57
■
“Controlling the Server and Domains” on page 67
■
“Understanding Server Configurations and Failover Behavior” on page 79
Remove an eUSB Disk
This procedure can be performed only by qualified service personnel after removing the
CMIOU that contains it.
Servicing eUSB Disks 203
To Next Page
Loading...
Need help?
General