Install an eUSB Disk
Related Information
■
“Install an eUSB Disk” on page 205
Install an eUSB Disk
1.
Install the new eUSB disk.
a.
Position the new eUSB disk in the CMIOU (panel 1).
Ensure proper pin engagement with connectors before pressing the eUSB disk in place.
b.
Tighten the green screw to secure the eUSB disk to the CMIOU (panel 2).
2.
Reinstall the CMIOU cover and slide the cover forward until the latch clicks into
place.
3.
Reinstall the CMIOU you removed to access the eUSB disk.
See “Install a CMIOU” on page 102.
4.
If you have not already done so, connect to the host and restart it.
Connect to the host console in a separate terminal session before starting the host to ensure that
you can view all messages reported by the system.
-> start /Servers/PDomains/PDomain_x/HOST/console
Are you sure you want to start
/Servers/PDomains/PDomain_x/HOST/console (y/n) ? y
Servicing eUSB Disks 205
To Next Page
Loading...
Need help?
General