Oracle SPARC M8 - Page 107

330 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

DIMM Configuration

The SPARC M7 CMIOU DIMM locations and the buffer chip (BOB) and DDR channel (CH)

numbers are as follows:

Servicing DIMMs 107

Table of Contents

Default Chapter5
- Table of Contents5
Using this Documentation13
Identifying Components15
- Server Front Components (SPARC M8-8 and SPARC M7-8 Servers)16
- Server Rear Components (SPARC M8-8 and SPARC M7-8 Servers)17
- Server Front Components (SPARC M7-16)18
- Server Rear Components (SPARC M7-16)19
- CMIOU Chassis Front Components20
- CMIOU Chassis Rear Components21
- Switch Chassis Front Components (SPARC M7-16)23
- Switch Chassis Rear Components (SPARC M7-16)25
- DIMM and Eusb Locations in a CMIOU27
- Supported Storage Devices28
- Understanding Server Cooling Zones29
  - CMIOU Chassis Cooling Zones29
  - Switch Chassis Cooling Zones31
- Component Service Task Reference32
Detecting and Managing Faults35
- Checking for Faults35
- Interpreting Leds44
- Performing Advanced Troubleshooting50
- Verify that a Fault Has Been Cleared54
- Clear a Fault Manually55
Preparing for Service57
- Safety Information57
  - Safety Symbols58
- Tools Needed for Service58
- Filler Panels and Modules59
- Component Service Categories59
- Find the Server Serial Number60
- Locate the Server61
- Prevent ESD Damage61
- Attach an Antistatic Wrist Strap62
- Prepare a Component for Return to Oracle64
Controlling the Server and Domains67
- Log in to Oracle ILOM (Service)67
- Prepare a Component for Removal68
- Removing Power from the Server or Domain69
- Returning the Server to Operation73
  - Switch on PDU Circuit Breakers73
  - Restart the Server or Host (Oracle ILOM)74
- Check the Power State of the Server or Host (Oracle ILOM)75
- Return a Component to Service75
- Oracle ILOM Service-Related Tools76
Understanding Server Configurations and Failover Behavior79
- SPARC M8-8 and SPARC M7-8 Configurations and Failover Behavior79
- Pdomains)79
- Pdomain)79
- SPARC M7-16 Configurations and Failover Behavior81
Servicing Cmious83
- CMIOU Configurations (SPARC M8-8 and SPARC M7-8 with Two Pdomains)84
- CMIOU Configurations (SPARC M8-8 and SPARC M7-8 with One Pdomain)85
- CMIOU Configurations (SPARC M7-16)85
- Mixed CMIOU Configurations86
- CMIOU Redundancy88
- SPARC M8 CMIOU Label89
- CMIOU Indicators and Leds90
- Prepare a CMIOU for Removal91
- Unseat a CMIOU93
- Remove a CMIOU95
- Return a CMIOU to Oracle98
- Reseat a CMIOU101
- Install a CMIOU102
Servicing Dimms105
- DIMM Configuration106
- DIMM Names108
- Determine Which DIMM Is Faulty (Oracle ILOM)109
- Determine Which DIMM Is Faulty (Leds)109
- DIMM Configuration Fault Messages112
- Remove a DIMM112
- Install a DIMM114
Servicing Sps117
- SP Firmware and Configuration118
- SP General Status Leds120
- SER MGT and NET MGT Port Locations and Numbering121
- Oracle ILOM Paths for Spms122
- Prevent Automatic SP or SPP Failover123
- Determine Which SP Is Managing System Activity123
- Determine Which SPP Is Managing DCU Activity (SPARC M7-16)124
- Change Which SP Is Managing System Activity124
- Change Which SPP Is Managing DCU Activity (SPARC M7-16)125
- Prepare to Remove an SP125
- Prepare to Remove an SPP (SPARC M7-16)129
- Remove an SP or SPP132
- Install an SP or SPP136
Servicing Pcie Cards141
- Pcie Card Slot Configuration and Numbering142
- Understanding Pcie Card Device and Service Paths143
  - Pcie Card Paths (Bottom CMIOU Chassis)143
  - Pcie Card Paths (Top CMIOU Chassis)144
- Supported Pcie Card Carriers and Pcie Cards145
- Pcie Card Installation Order Guidelines145
- Pcie Card Carrier Leds and Controls149
- Locate a Pcie Card in the Server150
- Prepare a Pcie Card for Removal151
- Remove a Pcie Card Carrier and Card from the Server156
- Install a Pcie Card into a Card Carrier158
- Install a Card Carrier into the Server159
- Restore a Pcie Card Configuration on an I/O Domain161
- Verify the Pcie Card164
Servicing Power Supplies165
- Power Supply Leds166
- Remove a Power Supply167
- Remove the Power Supply Shims (SPARC M8)170
- Install the Power Supply Shims (SPARC M8)172
- Install a Power Supply175
Servicing Fan Modules (CMIOU Chassis)179
- Fan Leds (CMIOU Chassis)180
- Remove a Fan Module (CMIOU Chassis)180
- Install a Fan Module (CMIOU Chassis)182
Servicing Fan Modules (Switch Chassis)183
- Fan Module LED (Switch Chassis)184
- Remove a Fan Module (Switch Chassis)184
- Install a Fan Module (Switch Chassis)186
Servicing Switch Units189
- Switch Unit Leds190
- Prepare a Switch Unit for Removal191
- Unseat a Switch Unit192
- Remove a Switch Unit194
- Reseat a Switch Unit196
- Install a Switch Unit197
Servicing Pdecbs199
- Remove a PDECB200
- Install a PDECB202
Servicing Eusb Disks203
- Remove an Eusb Disk203
- Install an Eusb Disk205
Servicing a CMIOU Chassis Fan Cable Assembly207
- Remove a Fan Cable Assembly207
- Install a Fan Cable Assembly212
Servicing the Front Indicator Panel217
- Remove a Front Indicator Panel217
- Install a Front Indicator Panel222
Servicing the Front Indicator Panel Cable227
- Remove the Front Indicator Panel Cable227
- Install the Front Indicator Panel Cable232
Servicing Power Modules235
- Remove a Power Module235
- Install a Power Module238
Servicing SP Trays243
- Unseat or Remove an SP Tray243
- Reseat or Install an SP Tray246
Servicing Batteries247
- Remove the Battery247
- Install the Battery250
Servicing Pdus253
- PDU and AC Connections253
- Prepare a PDU for Removal254
- Remove a PDU256
- Install a PDU262
Servicing the CMIOU Chassis269
- Remove a CMIOU Chassis269
- Install a CMIOU Chassis275
Servicing the Switch Chassis277
- Remove a Switch Chassis277
- Install a Switch Chassis283
Servicing SP Internal Interconnect Assemblies285
- Remove an SP Internal Interconnect Assembly286
- Install an SP Internal Interconnect Assembly290
Servicing Internal Interconnect Assemblies297
- Internal Interconnect Assembly Configuration298
- Remove an Internal Interconnect Assembly299
- Install an Internal Interconnect Assembly302
Servicing External Interconnect Assemblies305
- External Interconnect Assembly Configuration306
- Remove an External Interconnect Assembly307
- Install an External Interconnect Assembly311
Glossary317
Index323

Other manuals for Oracle SPARC M8

Security Guide16 pages

Related product manuals

Preview: Oracle SPARC

Preview: Oracle SPARC T5-2

Oracle SPARC T5-2

Preview: Oracle SPARC T5-4

Oracle SPARC T5-4

Oracle SPARC T5-8

Preview: Oracle SPARC S7-2

Oracle SPARC S7-2

Preview: Oracle SPARC T8-2

Oracle SPARC T8-2

Preview: Oracle SPARC T7-2

Oracle SPARC T7-2

Preview: Oracle SPARC T8-1

Oracle SPARC T8-1

Oracle SPARC T8 Series

Preview: Oracle Netra SPARC T4-1B

Oracle Netra SPARC T4-1B

Preview: Oracle Netra SPARC S7-2 Series

Oracle Netra SPARC S7-2 Series

Preview: Sun SPARC Enterprise T5140

Sun SPARC Enterprise T5140