Parker PD-04 Series

Parker Hannifin
P series User Guide 58
Figure 20. Example of Digital Output Signal Wiring
Note) For output signals DO1~ DO8, GND24 terminal is disconnected GND24.
 Example of Analog Input Signal Wiring
Please see ― 8.5 Analog Speed Override ― and ― 6.8.3 Torque Limit Setting ― for
operation of analog input signals.
The window if analog input signal is -10V ~ 10V.
Impedance of the input signals is approximately 22KΩ.
Example of resistance selection
R1
R2
5KΩ
6KΩ
10KΩ
12KΩ
Figure 21. Example of Analog Input Signal Wiring
 Example of Analog Output Signal Wiring
Please see ― 5.8 Analog Monitor ― for setting and scale adjustment of monitoring
signals. The window of analog output signal is -10V ~ 10V.
The resolution of analog output signals is 12bit.
The permissible maximum load current is 2.5[mA] or below.
The stabilization time is 15[us].