4: Repair Internal Assemblies — Front Case
104
Replacement
1 Install the UI PCA.
2 Install the fourteen ST 3x8 self-tapping screws, see Figure 70.
3 Plug in the cables, see Figure 69 for UI PCA R1.0 or Figure 71 for UI PCA R1.1.
4 Put the LCD Display Cable into the two plastic cable fasteners on UI PCA, see Figure 61.
5 Close the Case. See “Closing the Case” on page 149.
To Complete the Replacement
Run Performance Verification and Safety testing as described in the “Performance Verification”
chapter.
To Next Page
Loading...