25 Recording
316
The selection of pop-up keys available depends on the monitor you are using.
Quickstarting Recordings
To quickstart any type of recording using a pre-configured recordings template,
• Select the
Recor- dings SmartKey and then select the pop-up key of the recording type you want
to start.
Alternatively, you can
• Select the
Main Setup SmartKey, select Recordings, then select the recording type.
To quickstart a delayed recording,
• Select the SmartKey
Delayed Record to immediately start a delayed recording.
M1116B only
• You can also start a delayed recording by pressing the Run/Cont key on the recorder module.
Extending Recordings
Timed (non-continuous) recordings stop when their runtime is over. Continuous recordings continue
until stopped manually or by an INOP condition.
• To extend an ongoing recording by its runtime, reselect its
Start pop-up key once.
• To make an ongoing recording continuous, reselect its
Start pop-up key twice within 5 seconds.
M1116B
only
• You can also make an ongoing recording continuous by pressing the Run/Cont key on the
recorder module.
Stopping Recordings
Recordings stop automatically when the preset runtime is over, when the recorder runs out of paper,
when you open the recorder door or when the recorder has an INOP condition.
• To manually stop a recording, select the
Recor- dings SmartKey and then select the pop-up key
Stop All Recordng.
M1116B
only
• You can also stop a recording by pressing the Stop key on the recorder module.
Recording Without a Template
To record without a pre-configured template, selecting the waves you require,
Delayed Recordng Vital Signs
RT A Recordng Alarm Limits
RT B Recordng ST Segments
RT C Recordng ECG QT
Select Waves Setup Recordng
HiRes Recordng Stop All Recordng
All ECG Waves
To Next Page
Loading...