26 Printing Patient Reports
330
Printer Status Messages
Printer Status Message Possible causes and suggested action
Print job queued for <Printer
Name>
The report has been placed in the queue for the named printer.
Print job could not be queued
(insufficient resources)
Print job could not be queued
(queue is full)
Print job could not be queued (no
matching printer found)
The printer queue is full and the monitor cannot accept another report request.
Wait until some more reports have been printed, then try again, OR
A report has been triggered that uses a paper size unavailable with the target
printer. Try another printer, if available, or change the paper size of the print
request.
Cancelling all print jobs Delete All Reps has been selected in the Reports menu, OR
The Operating Mode has been changed from Monitoring Mode to
Demonstration or Service Mode.
Cancelling the active print job The current report is being canceled as the result of a user request.
Cancelling print jobs due to
patient discharge
When a patient is discharged, all queued reports are canceled except those
stored in the print database.
Cancelling # print jobs due to
hotstart
The monitor has restarted and all report requests have been canceled except
those stored in the print database. "#" is the number of reports canceled.
Printing failed: No report
configured!
A report has been triggered which has not been correctly set up. Enter the setup
menu for the report type to set up the report.
Prin
ting
on <Pr
inter
Name>
...
A report is in progress, or the monitor is waiting for the central printer to accept the print job.
unavailable -> job suspended
The chosen device is unavailable. Check that the printer is properly connected
and that paper is available. The requested report will start printing when the
printer becomes available.
Print database full -> job
suspended
The requested report does not fit into the print database. You can select another
printer to print the report (see “Unavailable Printer: Re-routing Reports” on
page 328). Alternatively you can delete another report from the
Reports Job
List
(using the Delete Report key) to create space for your report.
Job on
<Print
er Name> f
ailed
(data unavailable)
Job on
<Print
er Name> f
ailed
(printer unavailable)
Job on
<Print
er Name> f
ailed
(data requisition error)
A report cannot be started on the requested printer.
One of three reasons is shown in the status message:
• data unavailable - the connected X2 or MP5 has been removed before the
data for the report was transferred.
• printer unavailable - make sure the printer is plugged in, switched on, and
has paper loaded.
• data requisition error - an internal error has caused data required for the
report to be unavailable, try starting the report again.
Print job
on <P
rinter
Name>
done
The report has been printed.
To Next Page
Loading...